Linux Installation
Last updated
Last updated
The Agent installer link is created dynamically when downloaded. Once the agent is downloaded, it is available from "Settings & Reporting" -> "Deployment Management".
From this section, basic agent parameters can be configured by clicking the "Linux Agent Settings " button.
Agent Configurations
Settings Name
Explanation
Communication Interval
Agent communication interval to the Server
Data Sending Interval
Agent data send interval to the Server
Update Check Interval
Agent update check interval from the Server
Service Iteration Interval
Agent sleeps for this time after each cycle
Upload Data Chunk Size
Number of uploaded entries by one query
Once the settings are defined, click the "Save" button, and the system will redirect to the download page. Click the "Download Service Installer" button to download the agent.
It will redirect to a new tab, where a wget command is used to install and apply the agent's installation script. Please execute it on the servers and clients to install the agent.
wget --no-check-certificate -O ./script.sh "https://portal.cloudcyte.com/functions/<generated value>" && chmod +rwx ./script.sh && ./script.sh
Once the download button is clicked, it is created and signed.
Note 1: Because of its nature, some EDRs or AV solutions may consider this installer file malicious. Please whitelist this file on your endpoint security products. Also, the services and processes below are deployed. It is recommended that you whitelist them.
Services
Service Name
Display Name
laservice
laservice
Installation of Agent
After using the wget command, run the command at the endpoints to install the agent.
After installing the agent, it automatically registers to the system.
Checking Installation
After the agent is installed, it registers itself automatically with the Server. Please go to "Asset Management" -> "Endpoint Management" to see the agents. The device may take a couple of minutes to appear on this screen.
Agents should be able to access CyberCyte Server on Port 443 and https://download.cloudcyte.com websites. If the agent is not shown here, please check access to the portal on the client first. If the entry is successful, please wait for communication interval settings.
Once the agents are created in Endpoint Management, add them to the Linux Servers Group. Please navigate to "Rules & Policies" -> "Policy Management". Then, add the policy as in Figure 5. In some cases, you need to create the policy for this, following Figure 6. Finally, the endpoint should be added to a Linux-based operating system (Figure 6). After a while, you will see the data from these endpoints.
Please navigate to "Asset Management" -> "Endpoint Management" on the portal. All machines are synced with the table, and users can observe the machine/agent information from there.
Agents should be able to access CyberCyte Server on Port 443 and https://download.cloudcyte.com websites. If the agent is not shown here, please check access to the portal on the client first. If the entry is successful, please wait for communication interval settings.
Using Shell:
Execute these commands in the shell:
service=cybercyte_linux_agent.service; systemctl stop $service && systemctl disable $service && rm /etc/systemd/system/$service && systemctl daemon-reload && systemctl reset-failed || rm -rf /opt/CyberCyteAgent
Disabling the Agent:
Go to the "Asset Management" -> "Endpoint Management" on the portal. Right-click on the machine and disable the agent. This action only disables agent data collection, the agent will update itself but not collect any data.
